中文版 English  

 

About Formen

 

Products

 

Quality Assurance

 

Certification

 










 
Business Scope  
 
Water Cooling System | Solar PV | Machining | Stamping | Brazing

        The Canadian COOLIT Sys. Company is special in designing and producing the water cool system. They have produced many water cooling products used for CPU and VGA cooling in the computer. This system can also be used in the server. For TEC technology is adopted, the heat dispersedness capacity can be  0.11/W. This water cooling system also can be used for transducer, high-power electronic device, medical instrument or the controller with high working environmental temperature.    
    Before filling the coolant, all the units are tested if it is leak. We use the HELIUM to check the leakage, the system leakage rate should be less than 5X10-6mbar.l/s. In order to keep less air bubble in the system, we use the vacuum machine to fill the coolant. The coolant is factory filled and sealed. Because we use the anti-penetrated rubber tube, the cooling system is maintenance free. The pump is the heart of the cooling unit. The noise is lower than 25dB and the MTBF is 50000 hours for the ceramic bearing and shaft are used. The customer can install the monitor software and use the USB module to adjust the fan’s speed, which can get the best cooling and lowest noise.

       The traditional water cooling unit has a lot of individual components which need the customer to setup the system by themselves. Now our product has integrated all the components. The coolant is pre-filled and the thermal compound has been covered. It is so easy for the amateur use it. All the installation only need two steps: First install the water cooling head on the CPU; Second install the unit on the computer rear case. 

      The application of Building Integrated Photo voltaic systems is account for large part of the solar market. Compared with the conventional PV modules, BIPV not only generate the electricity but also reduce solar heating in the summer.

            We have the transformers Research and Development center. According to the customer’s requirement, we can design the toroidal transformers and inductors with high efficiency, high saturation  voltage, low noise, high quality.  

          

      

         We have some machining equipment, including CNC milling, CNC lathe, and 6-axile driller. We are special in producing copper, aluminum and stainless steel components.

New Product

   

           Formen has the tooling design center. We can design tooling to punch and forming steel sheet products. Specially, we are very professional for car exhaust tube’s hook.   

           New product

   

        Continuous brazing started from developed country in 1970s. We bought a brazing furnace in 2003. The brazing process can be used for stainless steel soldering, carbon steel soldering, copper brass soldering and composite brazing by the industries of automobile, air conditioning, water heater.

       Aluminum brazing is the new soldering technology, which depend much on the equipment and the process. We have a lot of experience on aluminum brazing.

       The components we brazed before as follows: fuel rail regulator, water heater, oil rail, copper seal valve, pressure sensor, carbon gear, coffee pot, heat exchanger, motor clutch, belt wheel, heat sink, water radiator, diesel pipe and so on. Also we provide the brazing for customer.

       New product

 

Wuxi Formen Technical Co., Ltd    All Rights Reserved

Address: 5# No. 16 Xihong Road, MeiCun Industrial Park Wuxi New district, Jiangsu Province

Tel0510-88158085,88158055  FAX0510-88158086  Emailshiquan.tan@formentec.com